The Watch Site banner

1 - 3 of 3 Posts

·
Senior member
Joined
·
31,970 Posts
Discussion Starter · #1 ·
(Probably only 6M26 owners will know what I'm talking about.) On the June 27th I noticed the date was reading 28. :( Did the all- reset procedure and adjusted the date settings. Upon completion of the date settings adjustment, with the hands on 6 o'clock and the date on 27, when I pushed the crown back in the date advanced to 28 and the hands advanced to 7 o'clock. To remedy, I reset the hands to 6 o'clock and the date to 26 (no action resulted when the crown was pushed back in). The following day (actual date 28), when the date had automatically changed to 27, I reset the date at 28. When the crown was pushed back in, the date remained at 28 and the hands at 6 o'clock. Will wait and see how it reacts from here on, especially on the next 26th date. :-[ (Note: Only other action was a battery change by third party early this month, but I did the all-reset and date/time adjustments at that time, and everything was fine until the 26th.)

Any 6M26 owners had similar experience with theirs?
 

·
Registered
Joined
·
386 Posts
normdiaz said:
(Probably only 6M26 owners will know what I'm talking about.)
...
Any 6M26 owners had similar experience with theirs?
Nothing like that, but please be aware that when doing the all-reset and hands-alignment the date must be also aligned to 1 !!!

Also it might be a battery that is getting somehow low or some dust inside that makes date advancement on certain days a lot more energy-intensive...
 

·
Senior member
Joined
·
31,970 Posts
Discussion Starter · #3 ·
Catalin said:
Nothing like that, but please be aware that when doing the all-reset and hands-alignment the date must be also aligned to 1 !!!

Also it might be a battery that is getting somehow low or some dust inside that makes date advancement on certain days a lot more energy-intensive...
Thanks for that reply, Catalin. Think you nailed it -- I may have forgotten to reset the date to "1" after re-set procedure. Repeated the re-set procedure including the return of the date to "1" before resetting the final date/time. Think that may have done the trick. I'll know for sure on June 30.
 
1 - 3 of 3 Posts
Top