The Watch Site banner
1 - 1 of 1 Posts

· Registered
476 Posts
Discussion Starter · #1 ·

Seiko Prospex Professional Diver SBBN007 300M Tuna Can

This is the highly sought after discontinued Seiko Tuna Can that's been replaced with the nearly identical SBBN017 that costs around $900 (and rising). A black bezel insert has been installed. Original silver bezel insert is included with the watch. It's in perfect working condition and keeping excellent time with Seiko's 7C46 quartz movement. No defects. Made in Japan. Tried it on once and never wore it outside the house. It fits surprisingly well on smaller wrists (6.5") because of the short lugs (44mm lug to lug). It feels lighter and fits better than a MM300 (50mm lug to lug) and SKX007 (46mm lug to lug) on my wrist. A very good-looking tool watch that looks 10 times better on the wrist.

Watch is in the US. I'll eat Paypal fees and shipping for CONUS. Selling for SOLD $660 shipped (CONUS) via USPS Priority with insurance. International shipping (USPS) at actual cost with full customs declaration and insurance (please ask first). Payment by PayPal (confirmed address) or USPS money order. Will also accept Southern California local pickup at a cash discount. Not looking for trades or lengthy PMs to haggle on prices (lower offers kindly ignored). PM (mention "Tuna") with questions and leave an email address for direct contact. Numerous references.

Condition: (95% TZ Scale) One small mark on bezel near the 32 minute mark. Case has a couple very light and faint marks as seen in photos.

Watch comes with original Seiko rubber strap, inner and outer boxes, manual and stamped warranty card.

Thank you for looking.

Note: The day wheel is both English and Kanji.

Condition: 95% TZ Scale
Movement: 7C46 Quartz
Crystal: Hardlex
Lume: Lumi Brite
Water resistance: 300m
Strap: Seiko 22mm rubber strap
Made in Japan
Case: Stainless steel case
Case diameter: 48mm without crown
Case thickness: 14mm
Lug to Lug: 44mm
Crown: screw-down
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.