The Watch Site banner

1 - 2 of 2 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Hello gents, I am preparing to install my superdome Crystal and have seen pics of this in two fashions... Which is the more correct? Fit the supplied gasket on the Crystal and then press OR fit the Crystal's gasket in the case then press the Crystal in? Thanks!
*also, does the above change when using stock gasket and aftermarket domed Crystal? Thanks!
**any other words of wisdom on this install would also be appreciated!
 

·
Registered
Joined
·
36 Posts
I think it should be cleaning out the gasket seated area first, placed gasket in the case and position crystal on top of it evenly , pressing it down with min strength and check again on the seating ensured it's equal at all side then finally firmly pushed it down.
 
1 - 2 of 2 Posts
Top