The Watch Site banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi everyone, after much searching and emails to what seems like everyone in the Seiko modding community about a bezel insert for the 7002-7010 midsize, I've come to the conclusion they are rarer than hens teeth.
Faced with this I could either stop mid project or do something about it myself!!!
I chose the later.....
I'm having 10 made for me out of copper. Laser cut and tumble polished.
My next hurdle is to decide on how to finish these. A flat colour would be easiest for me as I have no artistic flair at all, so for my first one I will paint with one colour and bake it for half an hour (I'm going to use pebeo porcelain paint 150°). Any suggestions or help would be greatly appreciated. I would dearly like a snowflake style bezel insert with markings if possible but, alas I don't know how.
Help me seikoholics you're my only hope.
 

·
Registered
Joined
·
4,913 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Wow. I'm in awe of what was achieved at sukko! Totally out of my league. I read earlier on another forum that their 7002-7010 was 34.3mm OD 29.3ID. I measured mine with caliper and it come in at 34mm OD 29.8mm ID so that's what I'm going for.
If only I had machines like sukkos at my disposal. Cheers.

Sent from my SM-G900F using Tapatalk
 
1 - 4 of 4 Posts
Top