The Watch Site banner
1 - 4 of 4 Posts

8 Posts
Discussion Starter · #1 ·
Hi everyone,

I have always replaced the batteries in my watches (I have 5 Seiko chronographs) that have screw or snap-on stainless steel backs but my Seiko 7T62 is gold plated and I am very wary of scratching the plating if I use my usual blade to remove its snap-on back.
What tool should I use to remove the back or should I leave it to Seiko Service Centre to do the job?

Best regards
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.