The Watch Site banner

1 - 8 of 8 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi:

I have a Citizen watch, 0610-H03299 Promaster.

I would like to order a replacement stem and possibly a crown.

Can someone tell me the correct stem and crown part number
and a good source?

I ordered what I thought was the right stem from Esslinger, but
it was too long...and I glued the crown to the stem! :-(

Appreciate any help/suggestions.

---Dave
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
I used "Loctite 603" to 'glue' it.

When you say "heat" are you talking hair dryer (vs. torch)?

---Dave
 

·
Registered
Joined
·
7 Posts
Discussion Starter #4
Actually, I was able to remove the crown. I discovered it isn't just the length of the stem that is wrong, the whole stem is wrong.

So I go back to that I need to know the proper stem number to order for a Citizen 0610-H03299 Promaster.

Part number and source would be GREATLY appreciated.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #7
Rob3rto and 7s26b.

I thank you both very much. I actually found Roberto's referenced site, and was VERY excited and proud of myself. I then ordered the 065-441 from Essenger and found out it wasn't right! That one is not the same as the broken one I have; the dimensions along the stem don't match/line-up. They are both almost exactly the same length but the thread length, and the other lengths are not the same.

When I opened up the watch, the mechanism is stamped 0610a. I'm wondering if the 'a' at the end would indicate a different stem type. When I tried "0610a" on the boley site it didn't return anything.

Any other thoughts/suggestions would be GREATLY appreciated!

---Dave
 

·
Researcher
Joined
·
5,271 Posts
Pikchers are gonna be needed.
 
1 - 8 of 8 Posts
Top