The Watch Site banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello folks,

Just about to take on this project. My only stumbling block so far is trying to figure out how to remove the encircled "Citizen" and "Digi-Ana" plates located on the top and bottom of the watch. Has anyone ever dealt with this? Are these glued on? Are they part of the machined watch case (less likely)?
Does anyone know if these can be removed so I can refinish the case?

Thank you in advance for any insight you may be able to provide.
451950
 
1 - 1 of 1 Posts
Top