The Watch Site banner

1 - 7 of 7 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter #1 (Edited)
Putting up for sale a NON-WORKING Citizen Altichron for parts or repair.
Watch had been running for the 5 years I had it(inclusive of battery changes when necessary) till about 3 months ago. No evidence of battery leak(as I do monitor the status of the watch quite frequently and would know if the battery has run out).
Both LCD display and analog hands did not work even when a new battery was inserted.
Bidirectional bezel has hairline scratches and clicks but is slightly loose with play when turning in either direction.
Hands have specks of either dirt or rot as evidenced in the pictures.
Crystal has a few hairline scratches.
Caseback has scuffs consistent with normal wear. All buttons depress as they should and are not stuck. Time able to be adjusted when done manually with crown.
Black PVD coating on case has worn off at the four corners of the watch(highlighted in the attached photos).
LCD display has very slight bleeding at the bottom(also highlighted in photos) that does not hinder time display. LCD display had been working and showing the time together with the analog display before the watch ceased working.
Lume on the dial still glows for a very short while after being exposed to sunlight.

Asking USD$45 plus additional international tracked air shipping fees from Singapore.
 

Attachments

1 - 7 of 7 Posts
Top