The Watch Site banner

1 - 6 of 6 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
I have the SNA411 and would love to put a rubber or leather band on it.
I just can't figure it out.
It's not an integrated bracelet, unless I am going blind.
Has anyone done it?
I can't fit the spring bar tool anywhere.

here is a pic of the watch in question.

 

·
Registered
Joined
·
2,504 Posts
Here's an under the skirt shot.


Looks like there is a spring bar entering the short lugs on the case. Can you see anything on the beveled area on the end link flanking the spot with the "33P9-8I" on the endlink?
 

·
Registered
Joined
·
2,504 Posts
TimeSeeker said:
Thanks.
Yes, I see it. So thats where the spring bar tool should go?
I didnt think to look upside down.
Yes, that's what I would try.

If you open up the bracelet by detatching it from the clasp, you will have more room to work. Push out the spring pin at the micro adjustment hole. Just don;t let it shoot across the room!

Its OK. We all have our brain farts. I once spent 30 minutes pounding out what I though was a split pin on the link of an Alpha bracelet only to discover that it was a screw. For the life of me I just couldn't figure out why the "pin" would not move.
 
1 - 6 of 6 Posts
Top