The Watch Site banner

1 - 4 of 4 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Thoughts and advice please -- My 6309-729A is acting strange! I put it on this morning and all was fine for about 45 minutes, then I noticed it had stopped. Maybe not wound? but I had been wearing it for all that time. Shook it and it restarted, so OK maybe it needs more movement, but it stopped again, and again. I discovered, not by any plan, but by accident having put it on the desk to look at later, that it was running OK on it's face. That's where I've got to because it will not run for more that 10 minutes on my wrist but runs continuously on it's face.
What would cause that? Any ideas or suggeestions?
 

·
Special Member
Joined
·
4,548 Posts
I agree with wengis here...that kind of watch behaviour can often signal that it needs a general overhaul. I have had the same experience with a 7548 diver...just needed cleaning.
 

·
Registered
Joined
·
1,951 Posts
Should be a simple fix if it runs dial up and say stops dial down then diashock need a clean or the balance is playing up something is loose etc.
 
1 - 4 of 4 Posts
Top