The Watch Site banner

1 - 3 of 3 Posts

·
Registered
Joined
·
865 Posts
Discussion Starter #1 (Edited)
Hi all, trying to place the bridge over the 3 pivots. Being trying for ages to get it right . Is there any tricks or tips anyone could offer up to make it any easier to align the minute recording wheel and the intermediate minute recording wheel which seems to be the real issue . With the intermediate wheel should the longer length pivot be on the down side.
Thanks T


Now moved over to the tinkering forum.
 

·
Registered
Joined
·
1,579 Posts
Probably a good post for the tinkering section.

Can't remember if there is anything tricky with this particular bridge, but my approach is always the same. I use a Component Probe (Bergeon 6436) to apply light downward pressure to the bridge. With light pressure you can then go into the side with some fine tweezers (preferably brass) and gently guide in any of the wheels that are not lined up. Also have a close look for anything else on the bridge that could be fowling.

There are guys here that will know all about this particular part.
 
1 - 3 of 3 Posts
Top