The Watch Site banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Pulled these out of a recent pogue purchase 6139 6005, but they seem to be a mixed pair. One is sticky. What have I got here :confused:, and what is the best thing to do. I'm thinking it will just be simplest to buy a pair of pushers that already have the new gaskets on ready to go. Thoughts please...
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #6 ·
Tom and Mike are both spot on of course.

... A little nice silicon grease on those, clean the funk off the case, and it will feel perfect.

Where are you in the world....I expect someone can send you a pusher...if you are in the UK then I can for sure...

And welcome to SCWF!
Hi,
thank you, I'm down under, Brisbane. Is there a particular silicon grease for watches? Else I have silicon grease that I use for my underwater camera housings?
Cheers
Russ
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top