I had my late father's 7008-8390 restored and it looked fantastic. I accidentally hit is against a doorframe as I walked through and popped the bezel, crystal and hands off.
To make matters worse I lost the bezel somewhere between home, my bag and the watchmaker.
I need a new...
Some information here for any owners of an SKX031 / SKX033
The bezel size as measured is: OD = 40.0mm / ID = 32.9mm
I was looking for a second bezel but find them hard to come by.
Parts for SKX007 can be found for a dime to the dozen !
The link below provides information about...
I won't reveal what this watch is just yet as I'm on the border making the purchase.
There's evidence of pitting and lifted chrome bits on the bezel.
I can sand and buff it with my 'Dremel' to restore the lustre but how can the lifted chrome bits be repaired?
I've seen chrome...
The mechanism was a little sticky so I decided to take the bezel off and give it a clean underneath
I think this is a different system to the SKX007/SKX009
Here I see a spring (which fits inside the cylinder with a flared end)
I was expecting to find a ball bearing on top of the...
I am looking to purchase a SS colour, outer bezel for my 4006-7002 Bellmatic. Does anyone have a spare lying in their top-drawer?
Also, any advice please on part numbers etc for a genuine SS bracelet would be much appreciated.
I am looking for a bezel that will fit a Seiko 6119-8460 "Gene Kranz" watch. I bought the watch but it did not come with a bezel. I also tried to buy a 6105 bezel but I missed out on that opportunity. Can anyone help?
I've reassembled a number of 4006 cases and never encountered a problem putting the bezel back on the case. However I've been stymied by the 7012. I can't seem to snap the bezel into place. My crystal press doesn't have enough headroom for an in-place crystal, so I can't use that approach. I'd...
I've recently inherited a battered 5719 Single Pusher Chrono from 1967 that is missing a bezel.
I'd like to get the watch restored and serviced, but I am struggling to find any NOS or Repro bezels for it. Anyone here know if there are any around or if someone is 3D printing some in batches...
Bezel for 7C46 golden tunas 7C46-7008, 7C46-7009 and 7C46-0AB0, part number 86310983 (old) / 86310984 (new).
Small surface scratches, but dosen't look like it's been used (no scratches on the inner side from turning the bezel).
SOLD for 75 Euros, payment via PayPal F&F or SEPA bank...
After removed bezel for cleaning, I tried to install it back. There's this Oring (gasket) suppose to be placed in the bezel before installing or to be placed over the case below the crystal then push in bezel?
I have problem pushing in bezel and crushing the oring when I pushed harder. Any...
Hello. I know little but have started researching.
My question is about replacing the bezel on a stock 6119-8140 sport diver. I'd like to have a bezel that has a coin type edge like you get on the similar bodied navi-timer or 'moon watch'.
Is it a direct fit or would it need modifications...
my SKJ needs the PEPSI bezel inlay to be replaced.
Does anyone know - where to get this?
My watch is a
the part Number is
I do not want to replace the complete bezel - just the inlay. Can anyone help me with this please?
Thanks in advance:sleep:
Hi all, my apologies if this question has been asked many times before, but does anyone know of a one-stop-shop for buying vintage diver Seiko bezels? Perhaps a website or individual retailer? I've searched eBay but haven't had any luck finding what I need. Thanks.